Reprocessing implies that the tailings material is used as a feedstock for producing valuable products such as recovered minerals and metals (Edraki et al., 2014).According to Gordon (2002), mine tailings can be observed as the single largest source of copper in waste deposits in the US copper cycle and Johansson et al. (2013) categorized tailings as valuable …
The effects of the reduction temperature, reductant dosage, and flux dosage on iron recovery from copper tailings were investigated using a combined process of the direct reduction and magnetic separation. The results confirm that it is feasibility of iron recover from copper tailings through direct the combined process. ... Equipment. The main ...
Mine tailings deposits are often overlooked by the industry, posing significant environmental challenges due to chemical hazards and inadequate maintenance. Nevertheless, such mineral deposits hold considerable economic potential for processing, and the adoption of innovative technologies may also address critical chemical and physical stability issues. …
The concentration of sulfide copper minerals by means of flotation generates large volumes of tailings. It is estimated that one hundred twenty-five tons of tailings are generated per one ton of produced copper, and its generation is on a continuous rise because of the decrease of the copper grades [1].On the one hand, the tailing is considered an environmental problem as …
cess route to produce magnetite pellet feed from copper o-tation tailings stored in a downstream raising dam located in Pará state in northern Brazil. Currently, the industrial plant processes 10.7 Mtpy of copper ore containing a feed grade of around 0.85 wt% of Cu, generating close to 10.4 Mtpy of copper tailings. The copper otation tailings con-
Fig. 3-Splral tests on desllmed oxide tailings and recovery of the lead minerals, which have a higher relative density, again surpassed those for copper or zinc, the recovery of copper and lead being 25 and 28 per cent respectively at a grade of 5 per cent each. The recovery of copper dropped off rapidly as the grade of the con-
A flowchart for the copper recovery from flotation tailings using flotation‒high‒pressure leaching‒solvent extraction Based on the results from the experiments conducted and described in the preceding sections in this paper, a flowchart for recovery of copper from the flotation tailings can be proposed as shown in Fig. 17.
This work aims at the recovery of residual copper from low grade tailings (up to 5% copper, and high grade in polymeric material), by applying simple physical methods to counterbalance the relatively increased cost of the subsequent chemical treatment. The tailings originated from waste electrical cable treatment for copper recycling.
Copper cementation is described by the following reactions (Stefanowicz et al, 1997): Cu2þ þ Fe0 →Cu0 þ Fe2þ 0 The samples used during the tests originated from the tailings of a recycling plant dealing with the recovery of copper from electrical cables, after comminution to less than 4–5 mm and subsequent airseparation of copper wires ...
tailings storage facility and, therefore, the owner may decide to close it or put it into a non-active state," he said. One company looking to address the. availability and cost of specialised technology for . reprocessing tailings and other 'waste' is CDE. An industry-leading manufacturer of wet. processing equipment for materials ...
This suggests, copper could be recovered from non-magnetic cleaner tailings, which corresponds to 4% of copper fed in flotation tailings. Considering the three steps, that is, screen classification, rougher, and cleaner magnetic separation, the total mass recovery is 3.02% (3.02% = 6.33% × 47.69%) and Fe and SiO 2 recoveries were 31.73% and 0. ...
The geologic types, amounts, and even locations of copper mine tailings from Arizona's 100+ years of mining are only partially known, as is their critical metal content. ... and what reagents and equipment cost, as inputs to Task 3. ... of economically reprocessing copper mine tailings to recover critical metals from the tailings sampled and ...
to recover Cu, Fe, and Mn from low-grade copper tailing effectively using an environment-friendly and economical leaching method. Materials and Methods This present research was laid out to study the metal recovery from copper tailing through acid leaching. For this purpose, the solid material samples were brought into the Environmental re-
The objectives of the copper plates implementation plan are the following: • Present the technical criteria for the manufacture and operation of the copper plates for the recovery of mercury from tailings. • Design the framework of an economic plan detailing the implementation costs of the copper plate technique.
Considering the price of copper in the world and the environment protection policy of China, a possible recovery of copper from tailings by flotation can be obtained. Download: Download high-res image (321KB) ... The commissioning process was carried out, and the parameters of the flotation equipment for Cu flotation are presented in Table 4.
The case study features Chilean copper mine tailings, to analyze the ones with significant volume among the 740 tailing storage facilities present in the country. Mine tailings deposits that are currently active were analyzed, using geochemical content information provided by The National Service of Geology and Mining (SERNAGEOMIN).
Aldrich and Feng (1999) observed an improvement in the ultimate recovery of sulfur from Merensky Reef, Africa, using ultrasound treatment, despite the negative effects of the concentration of solids, temperature, conditioning time and gas flow. Meanwhile, Vargas et al. (2006) found that conditioning by means of ultrasonic radiation could preserve the …